Krone EasyCut R 280 - Page 83

index
83
15 index
A
Abrasion Limit.....................................................58
Adjusting Skids ...................................................74
Adjusting the Compensation Springs .................43
Adjusting the cutting height ................................42
Adjusting the lateral suspension arm..................38
Affixing the Adhesive Safety and Information
Labels .................................................................20
After Shearing Off...............................................66
Attached devices ................................................13
Attaching the parking supports...........................76
B
Before mowing....................................................35
Before the Start of the New Season...................71
Blade Changing on Cutting Discs.......................59
Blade Quick-Fit Device .................................55, 61
Blade screw connection......................................54
Blade Screw Connection ....................................60
C
Checking the Cutter Blades and Blade Holder...52
Clutching points ..................................................22
Commissioning ...................................................21
Connecting the hydraulic lines............................27
Contact..................................................................7
Cutter Blades......................................................53
D
Dangers in Case of Non-compliance with the
Safety Instructions ..............................................11
Detaching the machine.......................................39
Deviating Torque ................................................47
Driving and Transport .........................................32
F
Filling Quantities and Lubrication Designations for
Gearboxes ..........................................................48
First installation...................................................21
Folding down the Safety Device .........................36
Four supports..........................................31, 37, 40
Friction Clutch.....................................................73
From transport into working position ..................34
H
Headland Position...............................................38
Hydraulic spring compensation mechanism.......78
Hydraulic system ................................................15
Hydraulics ...........................................................27
I
Identification Plate................................................ 8
Identifying Symbols in the Operating Instructions
........................................................................... 10
Inadmissible Modes of Operation ...................... 16
Information Required for Questions and Orders.. 8
Install the PTO shaft .......................................... 30
Intended Use........................................................ 9
Intermediate PTO shaft...................................... 30
Introduction .......................................................... 7
L
Lubrication Chart................................................ 69
M
Main gearbox ..................................................... 49
Maintenance ................................................ 15, 45
Maintenance – lubrication chart......................... 68
Mounting onto the Tractor............................ 22, 25
Mower Drive Gearbox........................................ 50
O
Oil Level Check and Oil Change Intervals
(Gearboxes)....................................................... 48
Oil level check and oil change on the cutter bar 51
Operation ........................................................... 34
P
Periodical Inspection of the Cutting Discs / Blade
Drums................................................................. 57
Periodical Inspection of the Leaf Springs .......... 56
Personnel Qualification and Training................. 11
Placing in Storage.............................................. 70
Position of the Adhesive Safety Stickers on the
Machine ............................................................. 18
PTO operation.................................................... 14
PTO shaft............................................... 23, 29, 68
Purpose of Use .................................................... 7
R
Re-Ordering the Adhesive Safety and Information
Labels ................................................................ 20
Replacing the linings.......................................... 62
Rotary hub with shear fuse (optional)................ 64
S
Safety................................................................. 10
Safety Instructions and Accident Prevention
Regulations........................................................ 12
Safety-conscious work practices ....................... 11
Setting of the pole protection mechanism ......... 44