V - 2
Service and maintenance
5.3 Tyres
Check the tyre pressure at regular intervals (all 100 h)
and top up air if necessary. The values can be taken
from the adjacent table.
• Installing wheels and tyres requires sufficient knowledge and the availability of proper tools!
• Repair work on the tyres and wheels may only be carried out by specialists using appropriate
tools!
• Set down rotary swather on firm, even ground. Prevent unintended rolling away with wedges.
• Regularly check that wheel nuts are properly seated and tighten if necessary!
• Regularly check air pressure!
Retighten the screws (1) of the tines to the correct
torque after first use.
SW46T019
1
5.3.1 Tyre pressure
The tine arms can be individually replaced if necessary.
• Remove screws (1) of tine arm
• Loosen the screws (2) of adjacent tine arms
• Pull out tine arm (3) and replace
• When refitting new tine arm ensure that the guide is
properly inserted into the curved track.
• Tighten all screws to correct torque (105 Nm).
5.4 Replacing the tine arms
(in case of repair)
SW700031
3
1
2
Swadro 46 T Tyres Tyre pressure [bar]
Tandem axle 18 x 8.50-8 6 PR 1,0
To Next Page
Loading...
Need help?
General
