IV - 3
Adjusting the swather
4.6 Swath former
The distance between the swath former and the swather
disc is infinitely adjustable for narrow or wide swaths to
suit crop conditions.
The distance between the swath former and the swather
disc is set to suit the amount of crop.
large crop = larger distance
small crop = smaller distance
To do this:
• Loosen the clamping lever (3)
• Move the swath former to the desired position
• Tighten the clamping lever (3) again.
The swath former can be adjusted lengthways in
8 positions. This adjustment is necessary if feed falls
forward past the swath former, for example.
To do this remove screws (5), put the swath former into
the desired position and replace screws (5).
To achieve optimal work results, the transverse
inclination of the rotor can be changed on the left and
right tandem axles.
Do not step under the rotors when they
are raised.
• To ensure this, raise the rotor just far enough to be
able to perform the adjustment tasks on it.
• Remove the left and right tandem axle and mount
again in the desired position with adjustment axle.
If the forage is heavy, adjust the running
gear on the swath cloth side as low as
possible.
4.5 Lateral inclination setting of
the rotor running gear
KS300103
1
2
I
II
To Next Page
Loading...
