VII - 1
Lubrication
7 Lubrication
Before correcting any operational
faults or carrying out any repair,
maintenance or cleaning work, always
disengage the driving system, stop the
engine and remove the key from the
ignition!
All lubrication points are shown on this page. You can
ensure a long service life of the implement by observing
the maintenance and lubrication intervals specified here.
20h
SW700027
8h
20h
20h
20h
20h
40h
40h
Swather disk gearbox (2) and swather disk housing (1)
are maintenance-free. (grease lubrication)
Lubricate universal drive shafts with a multi-purpose
grease at the intervals taken from the figure. Observe
the operating manual provided by the manufacturer of
the universal drive shaft.
7.2 Bearings on the swather
7.1 Universal drive shaft
It is preferable to use plant-based oils and
greases.
To Next Page
Loading...
