X - 1
10 Extras/accessories
10.1 Support wheel with chain
primary top link
The supporting wheel (5) must always be used so it is
allowed to coast down by continuing to rotate!
Installing the supporting wheel:
• Install the flange plate (1) on the cross bar (2) and
on the mounting link (3) of the three-point block.
• Install the supporting wheel support (4) on the
flange plate (1).
• Insert the supporting wheel (5) in the supporting
wheel support (4) and secure it in place with the bolt
(6) and spring cotter pin (7).
• Install the upper link with bolt (8) in the oblong hole
of the upper link plates and secure with linch pin (9)
Height adjustment:
The working depth can be adjusted by changing the
level at which the supporting wheel (5) is mounted in
the supporting wheel support (4).
Fitting the tine loss protection
The tine loss protection for the twin-spring tine consists
of:
— a cord
— two cord clamps with
— two each of saucer-head screws, washers and
locknuts
Secure the cord (1) to the swath disc tines (3) with the
cord clamps (2).
The cord should be situated behind
the swather disc tines in relation to the
direction of rotation. The nuts (4) on
the cord clamps should be pointing
outwards.
10.2 Tine loss protection
• The basic rule for servicing, maintenance, repair and assembly work on the rotary
swather - switch off the PTO shaft.
• Switch off the engine and remove the ignition key.
• Secure the tractor and rotary swather from rolling away!
Use a rigid top link arm for road transport!
To Next Page
Loading...
