II - 2
Safety
8. Carrying passengers during operation and transport on
the working implement is not permitted.
9. Attach implements correctly! Attach and secure
implements to specified devices only!
10. When attaching or removing implements, place the
supporting devices in the correct positions!
11. Use extreme caution when attaching or detaching
implements onto or from the tractor!
12. Always attach ballast weights properly to the fixing
points provided!
13. Observe permitted axle loads, gross weight and transport
dimensions!
14. Check and attach transport equipment such as lighting,
warning devices and any protective equipment!
15. Actuating mechanisms (cables, chains, linkages etc.)
for remote controlled devices must be positioned in such
a way that no movements are unintentionally triggered at
any transport or working positions.
16. Ensure that implements are in the prescribed condition
for on-road travel and lock them in place according to the
manufacturer's instructions!
17. Never leave the driver's seat when the vehicle is moving!
18. Always drive at the correct speed for the pre-vailing
driving conditions! Avoid sudden changes in direction
when travelling uphill or downhill or across a gradient!
19. Attached implements and ballast weights affect the
driving, steering and braking response of the machine.
Make sure that you are able to brake and steer the
machine as required!
20. Take into account the extension radius and/or inertia of
an implement when turning corners!
21. Start up implements only when all protective devices
have been attached and set in the required position!
22. Keep clear of the working range of the machine at all
times!
23. Do not stand within the turning and slewing range of the
implement!
24. Never operate the hydraulic folding frames if anyone is
inside the slewing range!
25. Parts operated by external power (e.g. hydraulics) can
cause crushing and shearing injuries!
26. Before leaving the tractor, lower the implement onto
the ground, switch off the engine and remove the
ignition key!
27. No one should stand between the tractor and the
implement unless the vehicle has been secured
against rolling with the handbrake and/or wheel
chocks!
2.3.1 Mounted implements
1. Before mounting implements on/from the three-point
linkage, all controls have to be positioned in such a
way that any unintentional lifting or lowering of the
machine is impossible.
2. In case of three-point mounted implements it is essen-
tial that the hitch category of the implement matches
that of the tractor.
3. The three-point linkage includes shearing and pinching
areas.
4. When operating the outer controls of the three-point
linkage do not step between tractor and implement.
5. When the implement is in transport position assure at
all times a sufficient lateral limitation of the tractor
three-point linkage.
6. When travelling on public roads with implement raised
make sure the control lever is secured against lowering.
2.3.2 Power Take-Off Operation
1. Use only PTO shafts specified by the manufacturer!
2. The guard tube and guard cone of the PTO and the
PTO guard must be attached and in good working
condition (on the implement side, too)!
3. Make sure that the required tube covers are in place
for PTO shafts in transport and working position!
4. Before installing or removing PTO shafts, disengage
the PTO, switch off the engine and remove the ignition
key!
5. When using PTO shafts with an overload safety or
free-running coupling which are not shielded by the
guard on the tractor, mount the overload safety or
free-running coupling on the implement side!
6. Always make sure that the PTO shaft is properly
installed and secured!
7. Attach chains to prevent the PTO shaft guard from
rotating with the shaft!
To Next Page
Loading...
