Krone Swadro 46 - Fitting the Swath Former

X - 2
10.3 Fitting the swath former
Insert reinforcements (1) (3 x 40 x 540 4 pieces) and round
steel (2) (20 x 595) into the resting brackets on the swath
former (3). Screw the swath former (3) with the steel strip
(4) (2 x 30 x 1065 2 pieces) on to the angle bar (5) (M 6 x
25, washer 6.4 x 18 x 1.6 and locknut NM 6). Screw on the
round steel (2) between angle bar and the bracket (M 10 x
50 and locknut NM 10).
The NM 10 lock nut must not be tightened. The round steel
must be able to swing freely.
6
1
2
3
4
5
KS571025