Chapter 4 Maintenance Mode Functions
118
–Strong
–Weak
7. To require users to enter this password when they swipe a Maintenance badge,
enable Require Password with Badge.
8. Tap Save Settings.
Change Database Password
Use the Change Database Password function to change the password for a
database.
1. Tap Edit Advanced Settings.
2. Tap Change Database Password.
3. Enter the new password, which must be eight characters in length, and contain
at least one of each of the following: uppercase letter, lowercase letter,
number, and special character. Tap Enter.
4. Re-enter the new password and tap Enter.
5. Tap Save Settings.
Factory Defaults
Use Factory Default to restore the device settings to the factory default settings.
Caution: Use the Factory Default settings only if the timeclock is not operating
properly. You lose all previous settings and data when you perform this function.
1. Tap Edit Advanced Settings.
2. Tap Factory Defaults.
3. To confirm your selection, tap Restore. The timeclock reboots.
To Next Page
Loading...
