KSB Delta Macro F User Manual

7 Operation
43 of 92
KSB Delta Macro
1983.843/04-EN
7.3.2 Changing the operating mode
Fig.20: Information on the
pump
ü The screen has been unlocked. (ðSection7.3.1,Page42)
1. Select the symbol of the required pump, e.g. Pump1. Press the turn/push
button.
ð The symbol of the current operating mode of this pump set starts flashing.
2. Turn the turn/push button to select the symbol of the required operating mode.
3. Press the turn/push button to confirm your selection.
7.3.3 Resetting messages
*x*If a message is active for a part of the pressure booster system, a red bar is
displayed next to the corresponding symbol.
If a message is active, the corresponding ID is displayed at the bottom right.
(ðSection10.3,Page80) If several messages are active, the corresponding IDs are
displayed alternately.
All messages can be reset at once via the control unit.
If individual messages need to be reset, this can only be done via the app.
ü The screen has been unlocked. (ðSection7.3.1,Page42)
1. Select the Manual reset possible symbol. Press the turn/push button.
ð All active messages are reset.
Messages that need to be reset manually can only be reset when their cause has been
eliminated.
7.3.4 Setting the setpoint
The setpoint serves to select the required discharge-side pressure. The setpoint has to
be set at the discharge-side sensor. (ðSection7.2.5,Page41)
ü The screen has been unlocked. (ðSection7.3.1,Page42)
1. Select the Discharge-side sensor symbol. Press the turn/push button.
ð Position7 flashes and displays anS as well as the current setpoint.
2. Turn the turn/push button to adjust the displayed setpoint in increments of 0.1.
3. Press the turn/push button to confirm the displayed setpoint.
7.3.5 Activating the Bluetooth connection
1. Press the turn/push button for a minimum of 5seconds.
ð The Bluetooth connection symbol flashes. (ðSection7.2.2,Page40)
While the Bluetooth connection symbol flashes, the control unit can be connected to a
wireless device.
An existing connection is displayed by a continuously lit Bluetooth connection symbol
on the screen.
If no connection is established, the flashing Bluetooth connection symbol extinguishes
after some time.
7.3.6 Displaying the firmware version
Every time the pressure booster system is re-started the firmware version is displayed
for a short time. (ðSection7.2.5,Page41)
To have the firmware version displayed without re-starting the pressure booster
system, proceed as follows.
1. Turn the turn/push button to select the Locking/unlocking the screen symbol.
Then press the turn/push button.
ð The symbol flashes.
2. Turn the turn/push button to select the Servicing required symbol.
ð The firmware version is displayed on the bottom left and bottom right.

KSB Delta Macro F Specifications

General

Brand	KSB
Model	Delta Macro F
Category	Water Pump
Language	English