VOCAL MESSAGES
ALARM TRANSMISSION SYSTEM
REMOTE CONTROL OF THE SYSTEM
Up to 400 distinct vocal messages can be recorded in the system, with almost 15 minutes recording time. They
will warn the user in case of alarm or fault (with a specic message for every zone) or guide the user in the various
functions of the system. The vocal messages are managed by gemino (if sent via GSM) or by pontis (if signalled via
PSTN), or are reproduced locally on the ergo keypads.
They can be recorded in 3 different ways:
• Through the microphone of your PC
• By importing wave les
• By means of two text-to-speech (TTS) vocal synthesis programs, both available through basis
3
.
DEVICE SMS VOCAL MESSAGES E-MAIL SIA IP (DC-09) CONTACT-ID
lares IP
ETHERNET
gemino BUS
GSM / GPRS
pontis
PSTN
The system can easily be remotely managed through the following available options, namely by:
• Using the integrated web-server (see Ethernet connectivity - LAN network)
• Just calling the system via GSM or PSTN through the guided menu
• Sending an SMS (gemino BUS expansion board is required)
3 One engine is offered free of charge and is of normal quality; the second is of excellent quality (LOQUENDO TTS is a registered trademark
of LOQUENDO S.p.A.) licensed under a one-off payment. With the latter the installer can program the lares series systems, the gemino series
communicators, and other future devices.
MONITORING THE POWER SUPPLY
lares monitors both the external power supply voltage and the battery. It periodically checks the efciency status
of the battery, and will issue a warning in the case of problems. Moreover, in case of prolonged absence of power
supply, the system turns the battery off to prevent deep discharges. This is not merely a protective measure: it is the
system itself that disconnects the battery and, before switching itself off, lares performs all of the necessary checks,
stores the switch-off date and time for any subsequent checks and then switches the system off without causing any
faults. In this case the sirens will not sound, thus avoiding undue trouble.
NOTIFICATION REQIREMENTS
lares 16 lares 16 IP lares 48 lares 48 IP lares 128 IP
Notification
options
B (Grade 2) B, D (Grade 3) B, C, D (Grade 2/3)
Structure Type
Type Y (if lares IP not used, with pontis)
Type Z (with lares IP)
Type Y (if lares IP not used, with pontis and/or gemino BUS)
Type Z (with lares IP)
Signals transmission category: SP2 (pontis or gemino BUS), DP1* (pontis and gemino BUS), SP4 (lares IP or gemino BUS
with SIA DC-09 protocol) or DP3 (lares IP e gemino BUS with SIA DC-09 protocol)
* Not possible for lares 16 and lares 16 IP
Operational type of signals transmission: Pass-Through
To Next Page
Loading...
Need help?
General
