User Manual User Manual
51
52
Enable
Time
Set time
Heating
FLIM
Automatic
Automatic
ON
OFF
BMS
DOD
Disable
Disable
Enable
Maintain
SOC
Disable
Enable
Enable
Force
Wake
Disable
Disable
Enable
Grid
STD
1.China
Local
2. Germany
3.
Australia
AUS-A
AUS-B
AUS-C
4. Italy
5. Spain
6. UK
7. Hungary
8. Belgium
9. New Zealand
10. Greece
11. France
12. Bangkok
13. Thailand
14. South Africa
15. 50549
16. Brazil
17. 0126
18. Ireland
19. Israel
20. Poland
21. Chile
Chile_BT
Chile_HD
Chile_LD
22. Local
23. 60Hz
Run
Setting
REACT
MODE
Power
Factor
L0.80~L1.00
C0.80~C1.00
E
nable -
PF1.0
React
Power
L00%~L60%
C00%~C60%
QU
Curve
Disable
QP
Curve
the state of charge and depth
of discharge at the interval set.
If time is selected the user will
be prompted to enter a value
0…300 minutes.
Allows the user to enable or
disable the heating film
installed within the battery
modules. Automatic means
the system measures the
Outside temperature and turns
the film on as needed. Only
applicable if heating film is
requested at time of ordering.
Leave disabled. The inverter
will monitor depth of
discharge.
Disable: The minimum SOC
will not be maintained.
Enable: The minimum SOC 2%
is maintained. Whenthe battery
SOC is less than 2%, the grid
charges thebattery pack to 5%
through the inverter.
Enabling this option means the
battery will always remain
online and will not go to sleep.
Allows the user to select the
country that the system is
installed in.
The inverter can monitor
reactive power in several ways.
This setting is set according to
the selected grid standard and
should not be changed.
CEI0-21 ACEA
CEI0-21
Menu
Level 1
Menu
Level 2
Menu
Level 3
Menu
Level 4
Menu
Level 5
Menu
Level 6
Default
Selection
Comment
Menu
Level 1
Menu
Level 2
Menu
Level 3
Menu
Level 4
Menu
Level 5
Menu
Level 6
Default
Selection
Comment
EN50549
VDE0126
To Next Page
Loading...
