KTC COMPACK 2 SPECIAL - Page 57

CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020 page 57 of 63
Component
Verification
Maintenance
Control Type
HOURS
DESCRIPTION OF OPERATION
Operator control /
maintenance
Air filter
Replacement
4000 /
2 years
filter and pre-filter replacement
SP
Oil filter
Replacement
Replacing the oil filter and oil
recovery level
Air separator filter /
oil
Replacement
Changing the air / oil separator
filter
Oil replacement
(type Minerale2)
Replacement
lubricating oil Substitution
Oil replacement
(type Semi-synthetic
/ Sintetico2)
Replacement
lubricating oil Substitution
main electric motor
bearings
Control and
greasing
Grease the motor bearings with
grease specification
Belt drive
Control
(where
present)
belt tensioning control and
eventual
Belt drive
Replacement
(only for kpm
3,5)
Substitution of the belt and its
tension
Electric / remote
control switch panel
Control and
tightening
Terminals main electrical panel
terminals and contactors star /
delta
Suction regulator
Revision
Revision vacuum controller with
dedicated spare parts kit
Minimum air
pressure regulator
Revision
Revision minimum air pressure
controller with dedicated spare
parts kit
Thermostatic oil
circuit regulator
Revision
Revision oil thermostatic
controller with dedicated spare
parts kit