KTC COMPACK 2 SPECIAL - Page 58

CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020 page 58 of 63
Component
Verification
Maintenance
Control Type
HOURS
DESCRIPTION OF OPERATION
Operator control /
maintenance
Air filter
Replacement
8000
filter and pre-filter replacement
SP
Oil filter
Replacement
Replacing the oil filter and oil
recovery level
Air separator filter /
oil
Replacement
Changing the air / oil separator
filter
Oil replacement
(type Minerale2)
Replacement
lubricating oil Substitution
Oil replacement
(type Semi-synthetic
/ Sintetico2)
Replacement
lubricating oil Substitution
Suction regulator
Revision
Revision vacuum controller with
dedicated spare parts kit
Minimum air
pressure regulator
Revision
Revision minimum air pressure
controller with dedicated spare
parts kit
Thermostatic oil
circuit regulator
Revision
Revision oil thermostatic
controller with dedicated spare
parts kit
Belt drive
Replacement
Substitution of the belt and its
tension
Electric / remote
control switch panel
Control and
tightening
Terminals main electrical panel
terminals and contactors star /
delta
1
CAUTION in case of excessive reduction in the oil level, you can generate overheating phenomena with possible formation of
potentially flammable vapors
2
Type OIL The maintenance intervals / substitution with oil semi-synthetic / synthetic are doubled from 2,000 hours (with
mineral oil) to 4,000 hours