16 ELECTRICAL SYSTEM 169
S00298-10
–
Plug connector
2
into the new headlight bulb.
Low beam (H11/socket PGJ19-2) ( p. 207)
–
Position headlight bulb
1
into the bulb socket and turn it all the way clockwise.
The headlight bulb is locked into the bulb socket.
Finishing work
– Refit the headlight mask with the headlight. ( p. 167)
– Install the wind shield. ( p. 130)
–
Install the mask spoiler. x ( p. 123)
– Install the tank cover. ( p. 128)
– Install the front side cover. ( p. 119)
– Mount the seat. ( p. 107)
– Check the headlight setting. ( p. 172)
16.10 Changing the high beam bulb
Note
Damage to reflector Reduced brightness.
– Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before
mounting.
Preparatory work
– Switch off all power consumers and switch off the engine.
To Next Page
Loading...
