KTM 1290 SUPER ADVENTURE R - Installing the 12-V Battery

WORK 3
13
E02232-10
–
Disconnect negative cable
3
from the 12 V battery.
–
Disconnect positive cable
4
from the 12-V battery.
– Take the 12-V battery out of the battery compartment.
3.10 Installing the 12-V battery
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
– Keep 12 V batteries out of the reach of children.
– Wear suitable protective clothing and safety glasses.
– Avoid contact with battery acid and battery gases.
– Keep sparks or open flames away from the 12 V battery.
– Only charge 12 V batteries in well-ventilated rooms.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
Caution
Danger of accidents Electronic components and safety devices will be damaged if the 12-V battery is dis-
charged or missing.
If the 12-V battery is discharged or defective, malfunctions in the vehicle electronics can occur, espe-
cially when starting.
– Never operate the vehicle with a discharged 12-V battery or without a 12-V battery.
E02232-11
Main work
– Position the 12-V battery in the battery compartment.
–
Position positive cable
1
and mount and tighten the screw.
Guideline
Screw, battery termi-
nal
M6x12 4.5 Nm
(3.32 lbf ft)
–
Position negative cable
2
and mount and tighten the screw.
Guideline
Screw, battery termi-
nal
M6x12 4.5 Nm
(3.32 lbf ft)
E02231-11
–
Mount positive terminal cover
3
.
–
Attach battery retainer rubber
4
.