KTM 1290 SUPER ADVENTURE R User Manual

SETUP 2
3
2.1 Transport mode
H02713-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2 Unpacking and setting up the vehicle
F01344-10
– Remove the straps and the box.
E02439-10
– Remove the adhesive tape in the upper area of the motorcycle.
E02440-01
– Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking,
leave the other films on the vehicle until you have fin-
ished work on the vehicle.
– Remove the separate enclosure and unpack it. Check the sepa-
rate enclosure for completeness.
– Check the vehicle for transport damage.

KTM 1290 SUPER ADVENTURE R Specifications

General

Engine Type	2-cylinder, 4-stroke, V 75°
Displacement	1301 cc
Transmission	6-speed
Seat Height	880 mm
Weight (Dry)	221 kg
Fuel System	Electronic fuel injection
Cooling	Liquid cooled
Front Tire	90/90-21
Rear Tire	150/70-18
Power	160 hp (118 kW)
Torque	138 Nm
Fuel Tank Capacity	23 liters
Suspension Front	WP XPLOR 48 mm, adjustable
Suspension Rear	WP XPLOR PDS shock absorber
Clutch	PASC slipper clutch, hydraulically actuated
Frame	Chromoly steel trellis frame, powder coated
Front Brake	2 x Brembo 4-piston radial calipers, 320 mm discs
Rear Brake	267 mm disc, 2-piston caliper
Traction Control	MTC (Motorcycle Traction Control)
Wheelbase	1580 mm
ABS	Bosch 9.1 MP (Cornering-ABS and Offroad-ABS)