KTM RC 125 - 18.3 Adding Engine Oil

18 SERVICE WORK ON THE ENGINE 163
0
0
66
L02203-10
–
Remove filler plug

and the O-ring from the clutch cover and fill up with engine oil.
Engine oil 1.5 l (1.6 qt.) Outside temper-
ature: 0… 50 °C
(32… 122 °F)
Engine oil
(SAE 15W/50)
( p. 195)
Outside tempera-
ture: −10… 40 °C
(14… 104 °F)
Engine oil
(SAE 10W/40)
( p. 196)
– Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in
unconsciousness and/or death.
– When running the engine, always make sure there is sufficient ventilation,
and do not start or run the engine in an enclosed space without an effective
exhaust extraction system.
– Start the engine and check that it is oil-tight.
Finishing work
– Fit the front spoiler. ( p. 98)
– Install the left side cover. ( p. 101)
– Install the right side cover. ( p. 104)
– Check the engine oil level. ( p. 160)
18.3 Adding engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.