Plow - 110 RT120Q Operator’s Manual
Set Up
Feed Product
1. Remove cable guide.
2. Feed cable through tube from top to
bottom.
3. Replace cable guide and tighten
fasteners.
4. Secure cable.
Prepare Tractor
1. Fasten and adjust seat belt.
2. Start tractor.
3. Adjust to low throttle.
4. Move ground drive control to low.
5. Lower reel carrier to lowest position possible, if equipped.
6. Raise backfill blade, if equipped.
7. Tilt steering wheel column up.
8. Turn seat to the desired position.
9. Engage axle lock.
NOTICE: Use only genuine Ditch Witch
®
cable guide.
NOTICE: Use extreme caution when operating reel carrier on sloped surfaces.