RT120Q Operator’s Manual Drive - 87
Shut Down
Shut Down
1. When job is complete, drive unit to level ground.
2. Move ground drive control to neutral.
3. Set parking brake and verify parking brake indicator is on.
4. Lower all unstowed attachments to ground.
5. Run engine at low throttle for three minutes to cool.
6. Turn ignition switch to STOP. If leaving machine unattended, remove key.
7. For maintenance or long-term storage, turn battery disconnect switch to disconnect position.
NOTICE: To avoid equipment damage, wait two minutes after turning engine off before
disconnecting battery.
To Next Page