RT120Q Operator’s Manual Plow - 109
Set Up
Position Tractor
1. Fasten and adjust seat belt.
2. Start tractor. See page 84 for start-up procedures.
3. Drive to starting point. Move in line with planned trench. See “Drive” on page 85.
4. Set parking brake and verify parking brake indicator is on.
5. Lower backfill blade, if equipped.
6. If equipped with combo, set trench/plow switch to the plow position.
7. Lower plow to starting point of trench.
8. Turn ignition switch to STOP.
Attach Product
Pull Product
1. Insert material into pulling grip.
2. Tape grip with duct tape.
IMPORTANT: If material must be at a constant depth, dig starting and target trenches.
To Next Page
Loading...
