RT120Q Operator’s Manual Saw - 143
Finish Job
Finish Job
1. When trench is complete, move ground drive hand control to neutral.
2. Adjust throttle to low.
3. Raise saw and stabilizers.
4. As saw clears top of trench, move attachment speed/direction control to neutral.
5. If equipped with traversing saw, return saw to center position.
6. Raise trench cleaner, if equipped.
7. Return seat to the drive position.
8. Tilt steering wheel column down.
9. Disengage axle lock. After disengaging axle lock, drive tractor in reverse 6’ (2 m) to fully disengage.
10. Drive a short distance away from work site. See page 85 for driving procedures.
11. Shut down tractor. See page 87 for proper shutdown procedures.
To Next Page
Loading...
Need help?
General
