Maintenance Port Parser Commands
54-0147
155
H.4 Tracking and Conical
Scan Commands
Target Location
Function: reports the target location in antenna frame; data
format is E### for elevation in degrees 000-900 and
A#### for azimuth in degrees 0000-3599 with
implied decimals
Command: TGTLOCATION
Response: Target Location = A = E###, A####
B = E###, A####
Analog Signal Strength Report
Function: reports signal strength from RF detector circuit in
A/D counts (000-FFF Hex)
Command: SIGLEVEL
Response: Signal Strength = XXXX
H.5 Sensor Module Commands
Report Platform Attitude
Function: reports vessel attitude indicated by sensor module
Command: ATTITUDE
Response: Pitch +/-PP.P, Roll +/-RR.R, Yaw YYY.Y
Compass Calibration Score
Function: reports compass calibration score
Command: CALSCORE
Response: Cal Score = XXX
Compass Calibration Enable
Function: enables the sensor module compass calibration
Command: CALON
Response: echoes the command
Compass Calibration Disable
Function: disables the sensor module compass calibration
Command: CALOFF
Response: echoes the command
Table H-5
Sensor Module Commands
Table H-4
Tracking and Conical
Scan Commands
To Next Page
Loading...
Need help?
General
