© 2016 Spectrum Brands, Inc.
1. Association Groups
The lock supports 2 association groups. Per Z-Wave Plus requirements, group 1 is
assigned to the Lifeline group. The Lifeline group supports the following unsolicited
messages:
Battery Report
Door Lock Operation Report
Notification Report
Device Reset Locally Notification
Group 2 is available for all Notification Reports and can be used to send notifications to
at most 5 other nodes.
2. Configuration Parameters
The Z-Wave door lock module supports the use of the configuration command class to
provide advanced configuration of the door lock over the Z-Wave network. This section
describes the configuration parameters supported by the door lock.
2.1 Configuration Parameters 1 through 30
Configuration parameters 1 through 30 are a one byte field used to set the type of user for
their corresponding user code. The following table shows the valid values for user code
types:
Reserved
Owner (Default)
Reserved
Guest (required for Year/Day schedules)
!
Worker (required for week day schedules)
"#$%
Reserved
$$
No User Code assigned
To Next Page
Loading...
Need help?
General
