© 2016 Spectrum Brands, Inc.
&'
Lock status LED (1:enabled)
&'
Autolock setting (1:enabled)
&!'
Buzzer (1:enabled)
&('
Secure Screen (for 916 only); reserved for all others
2.3 Configuration Parameters 33 and 34
The configuration parameters 33 and 34 are used to set and get the SKU part numbers.
The SKU is made up of 8 bytes. Each parameter consists of four bytes of data.
Parameter 33 contains the first four most significant bytes of the SKU, while parameter
34 contains the four least significant bytes of the SKU.
When setting the SKU, it must be done in two set commands, one for each parameter.
The order of programming the SKU does not matter.
Setting parameter 33 will program the first four bytes of the SKU. Setting parameter 34
will program the last 4 bytes of the SKU. Most printable values are accepted for the set
command.
When getting the SKU, it must be done in two get commands, one for each parameter.
The order of getting the SKU does not matter.
Getting parameter 33 will retrieve the first four bytes of the SKU. Getting parameter 34
will retrieve the last 4 bytes of the SKU.
2.4 Configuration Parameter 40
The configuration parameter 40 is a one byte field, used to set the lock to its default
setting, known as a factory reset command.
Reading this parameter will always return a value of 0.
Writing a value of 1 to this parameter will cause both the lock and Z-Wave card to reset
back to their default settings and will remove itself from the network. All network
information, including associations will be cleared.
To Next Page
Loading...
Need help?
General
