KYMCO ZING 150 - Steering Stem Installation

11. FRONT WHEEL/SUSPENSION/
STEERING
11
-
15
Remove the top and bottom ball races.
BALL RACE INSTALLATION
Drive the top and bottom ball races into the
steering head using a bearing driver.
BOTTOM CONE RACE REPLACEMENT
Drive out the bottom cone race.
Install a new washer and dust seal onto the
steering stem and then drive in a new bottom
cone race onto the steering stem.
STEERING STEM INSTALLATION
Bearing Driver Handle
Ball Race Remover
Bottom Cone Race
Attachment, 37x
40mm
Attachment, 37x40mm