System Menu > NetworkSettings
489
Ping
[System Menu / Counter] key > [NetworkSettings] > "Network Settings" [Ping]
Bonjour
[System Menu / Counter] key > [NetworkSettings] > "Network Settings" [Bonjour]
IP Filter (IPv4)
[System Menu / Counter] key > [NetworkSettings] > "Network Settings" [IP Filter (IPv4)]
IP Filter (IPv6)
[System Menu / Counter] key > [NetworkSettings] > "Network Settings" [IP Filter (IPv6)]
Item Description
[Ping] Check if you can communicate with the destination by entering the host
name or IP address of the destination.
NOTE
This function is not displayed when [Primary Network (Client)] is specified
in [Optional Network].
➡ Primary Network (Client) (page 495)
[Ping Timeout]
➡ Ping Timeout (page 419)
Item Description
[Protocol Settings] Select whether to use Bonjour.
Value: Off, On
[Available Network] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Description
[IP Filter (IPv4)] Configure the IP Filter Setting. IP Filter is a function to restrict the access
to the machine by the IP address and protocol.
The IP address or network address of permitted hosts is set from
Command Center RX. Not setting the IP Filter will allow access from all
hosts.
Value: [Off], [On]
➡ Command Center RX User Guide
To Next Page
Loading...
