System Menu > NetworkSettings
490
IPSec
[System Menu / Counter] key > [NetworkSettings] > "Network Settings" [IPSec]
Restart the network
[System Menu / Counter] key > [NetworkSettings] > "Network Settings" [Restart Network]
Item Description
[IP Filter (IPv6)] Configure the IP Filter Setting. IP filter is a function used to restrict the
access to the machine by setting the IP address and protocol.
The IP address or network address of permitted hosts is set from
Command Center RX. Not setting the IP Filter will allow access from all
hosts.
Value: [Off], [On]
➡ Command Center RX User Guide
Item Description
[IPSec] Set whether or not you use the IPSec.
Value: [Off], [On]
Item Description
[Restart Network] Restarts the network.
To Next Page
Loading...
