Troubleshooting > Troubleshooting
612
1
Connect the cable to the machine.
1 Connect the LAN cable to the network interface connector.
2 Connect the other end of the cable to the hub.
2
Power on the machine and configure the network.
➡ Network Setup (page 73)
Connect a USB cable to the machine.
IMPORTANT
If the power is on, turn the power switch off.
➡ Power off (page 44)
1
Connect the cable to the machine.
1 Connect the USB cable to the USB interface connector.
2 Connect the other end of the cable to the PC.
2
Power on the machine.
To Next Page
Loading...
