Printer Configuration
1-12
1.3 Printer Configuration
This section explains how to set and confirm the printer’s configuration
from the KM-NET Remote Operation Panel utility. The value set from the
KM-NET Remote Operation Panel utility becomes the printer’s default
setting. However, when printing, the printer may automatically switch to
another setting, depending on the application software or printer driver
settings.
1.3.1 Basic Settings for the KM-NET Remote Operation Panel
Before operating the KM-NET Remote Operation Panel, you can change
settings for polling, error notification, and whether you want to use the 3D
virtual printer to monitor the printer status.
1
Click the SETUP button on the start-up screen.
2
The KM-NET Remote Operation Panel dialog appears. Read the
following explanations, then make the appropriate settings.
Status Polling
Browse NIC Web Page button
Enable Traps
Polling
To Next Page
Loading...
