Print Quality Problems
3-5
Characters out of position. Check the file or program.
Check whether the problem is being caused by a
PRESCRIBE command error. If the problem occurs only
with a specific file or program, the most likely cause is an
error in a parameter to a command or command syntax.
Check the paper size setting.
Check that the paper size set in the paper source and the
paper size set on the KM-NET Remote Operation Panel
are the same. (See section 1.4.5 Paper Size on page 1-23
and Chapter 4)
Printed Results Corrective Action
Table 3-2 (Continued)
To Next Page
Loading...
