Kyocera FS-1028MFP

Panel Setup
14 SETUP GUIDE
• DHCP (DHCP setting)
• Bonjour (Bonjour setting)
• IP Address (IP address setting)
• Subnet Mask (Subnet mask setting)
• Default Gateway (Gateway setting)
DHCP
1
In the IPv4 Setting menu, press U or V to select DHCP.
2
Press [OK]. The DHCP screen appears.
3
Press U or V to select whether DHCP is enabled.
4
Press [OK]. The DHCP is set and the IPv4 Setting menu reappears.
Bonjour
1
In the IPv4 Setting menu, press U or V to select Bonjour.
2
Press [OK]. The Bonjour screen appears.
3
Press U or V to select whether Bonjour is enabled.
4
Press [OK]. The automatic Bonjour is set and the IPv4 Setting menu reappears.
IP Address
1
In the IPv4 Setting menu, press U or V to select IP Address.
2
Press [OK]. The IP Address screen appears.
3
Use the arrow keys to set the IP address.
Press U and V to increase or decrease, respectively, the value at the blinking
cursor. You can set any value between 000 and 255.
Use Y and Z to move the cursor right and left.
4
Press [OK]. The IP address is stored and the IPv4 Setting menu reappears.
Subnet Mask
1
In the IPv4 Setting menu, press U or V to select Subnet Mask.
2
Press [OK]. The Subnet Mask screen appears.
3
Use the arrow keys to set the subnet mask.
Press U and V to increase or decrease, respectively, the value at the blinking
cursor. You can set any value between 000 and 255.