Kyocera FS-1028MFP

Panel Setup
SETUP GUIDE 15
Use Y and Z to move the cursor right and left.
4
Press [OK]. The subnet mask is stored and the IPv4 Setting menu reappears.
Default Gateway
1
In the IPv4 Setting menu, press U or V to select Default Gateway.
2
Press [OK]. The Default Gateway screen appears.
3
Use the arrow keys to set the default gateway.
Press U and V to increase or decrease, respectively, the value at the blinking
cursor. You can set any value between 000 and 255.
Use Y and Z to move the cursor right and left.
4
Press [OK]. The default gateway is stored and the IPv4 Setting menu reappears.
IPv6 Setting (TCP/IP IPv6 settings)
This selects the settings for TCP/IP (IPv6).
1
In the TCP/IP Setting menu, press U or V to select IPv6 Setting.
2
Press [OK]. The IPv6 Setting menu screen appears.
TCP/IP(IPv6)
1
In the IPv6 Setting menu, press U or V to select TCP/IP(IPv6).
2
Press [OK]. The TCP/IP(IPv6) screen appears.
3
Press U or V to select whether TCP/IP (IPv6) is enabled.
4
Press [OK]. The TCP/IP(IPv6) is set and the IPv6 Setting menu reappears.
AppleTalk (AppleTalk setting)
AppleTalk is a communications protocol used primarily on Macintosh computers and
also refers to the Mac OS network functions. The default setting is On.
1
Press [System Menu/Counter]. The Sys. Menu/Count. screen appears.
2
Press U or V to select System.
3
Press [OK]. The System screen appears.
4
Press U or V to select Network Setting.
5
Press [OK]. The Network Setting screen appears.