Preparations
8 SETUP GUIDE
Available Standard Interfaces:
3
Connect the power cord to the machine and
the other end into a power outlet.
4
Turn the power switch on (|). The machine
begins to warm up. The machine will begin
replenishing the toner; this will take
approximately 15 minutes.
Once the toner has been replenished,
Ready to copy will appear on the
message display.
Connecting Modular Cords (FS-1128MFP only)
1
Turn the power switch off (O).
2
Be sure to loop the cord three times through
the ferrite core.
Interface Function Necessary Cable
Network
Interface
Printer/Scanner/
Network FAX
LAN (10Base-T or 100Base-TX, Shielded)
USB Interface Printer/TWAIN/
WIA
USB2.0 compatible cable (Hi-Speed USB
compliant, Max. 5.0 m, Shielded)
To Next Page
Loading...
