Chapter 3 Using the Operator Panel
3-16
Press the ENTER key again. The printer prints a
Code Job list as shown below.
Figure 3-6
Retrieving Jobs from Virtual Mailbox (VMB)
To retrieve the jobs posted in the virtual mailbox, proceed as
follows.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >Print VMB
Data appears. The virtual mailbox number will also
appear.
If you have named the virtual mailbox with an alias on
the printer driver, the alias (Richard, in this example)
will follow the number:
Press the ENTER key. A blinking question mark (?)
appears.
Press the ENTER key. The document in the mailbox
is printed and automatically deleted from the mail-
box.
Printing a List of VMB
A Virtual Mailbox list includes the jobs currently stored in
the mailboxes.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >List of
VMB appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key again. The printer prints a list of
jobs currently posted in the virtual mailboxes as shown
below.
Figure 3-7
Changing e-MPS Configuration
You can change the following parameters for e-MPS opera-
tion:
• Maximum number of Quick Copy/Proof-and-Hold jobs
• Maximum space assigned to temporary code jobs
• Maximum space assigned to permanent code jobs
• Maximum space assigned to virtual mailboxes
The total amount of storage area specified must not exceed the
total size of the hard disk. Otherwise, you may only be able to
accommodate a smaller number of print jobs than specified.
e-MPS >
>Print VMB Data
Tray001:
>Print VMB Data
Tray001:Richard
>Print VMB Data
Tray001?
6
PERMANENT CODE JOB LIST
1
2
3
4
5
6
e-MPS >
>List of VMB
>List of VMB ?
NOTE
1
2
3
4
5
6
VIRTUAL MAIL BOX LIST
To Next Page
Loading...
Need help?
General
Weight and Dimensions
