Using the Operation Panel
ADVANCED OPERATION GUIDE 2-31
Changing e-MPS Configuration
You can change the following parameters for e-MPS operation:
• Maximum number of Quick Copy/Proof-and-Hold jobs
• Maximum space assigned to temporary code jobs
• Maximum space assigned to permanent code jobs
• Maximum space assigned to virtual mailboxes
NOTE: The total amount of storage area specified must not exceed the
total size of the hard disk. Otherwise, you may only be able to
accommodate a smaller number of print jobs than specified.
Changing the Maximum Number of Quick Copy/Proof-and-Hold Jobs
This changes maximum number of Quick Copy/Proof-and-Hold jobs from
0 to 50. The default is 32.
1
Press [MENU] key.
2
Press U or V repeatedly until e-MPS >
appears.
3
Press Z.
4
Press U or V repeatedly until >e-MPS
Configuration > appears.
5
Press Z.
6
Press U or V repeatedly until >>Quick
Copy appears.
7
Press [OK]. A blinking cursor (_) appears.
8
Press U or V to increase or decrease the value at the blinking cursor. The
value can be set between 0 and 50. Use Z and Y to move the cursor right
and left.
9
When the desired maximum number of jobs is set, press [OK].
10
Press [MENU]. The display returns to Ready.
e-MPS >
>e-MPS >
Configuration
>>Quick Copy
32
>>Quick Copy
32
To Next Page
Loading...
