Using the Operation Panel
2-32 ADVANCED OPERATION GUIDE
Maximum Space Assigned to Temporary Code Jobs
This changes the hard disk space that holds temporary code jobs. You can
change the maximum space from 0 to 9999 (megabytes). The actual
maximum size depends on the size of free hard disk space, however. The
default size is 1/6 of the total hard disk space, rounded off in units of 50
MB. For example, if the total hard disk space is 3.2 GB, the default size is
500 MB.
1
Press [MENU].
2
Press U or V repeatedly until e-MPS >
appears.
3
Press Z.
4
Press U or V repeatedly until >e-MPS
Configuration > appears.
5
Press Z.
6
Press U or V repeatedly until >>Temp.
Code JOB Size appears.
7
To change the maximum disk space, press
[OK]. A blinking cursor (_) appears.
8
Press U or V to increase or decrease, respectively, the value at the
blinking cursor. Use Z and Y to move the cursor right and left.
9
When the desired size is displayed, press [OK].
10
Press [MENU]. The display returns to Ready.
e-MPS >
>e-MPS >
Configuration
>>Temp. Code JOB
Size 0500MB
>>Temp. Code JOB
Size 050
0MB
To Next Page
Loading...
