System Maintenance Reference
96
Message Cause/ Solutions
Turn off the power, turn it back on, and then perform
the update again.
If this message reappears after you turn the power
back on, see "Error and Status Messages on the
Screen" in the User Guide.
The IP address specified for either the machine or your
computer is invalid.
Check that both IP addresses are valid.
The [F/W Update (USB)] or [F/W Update (NET)] button
was clicked when the update was already in progress.
Clicking the [F/W Update (USB)] or [F/W Update
(NET)] button during the update process does not
interfere with any ongoing update.
Ignore this error message and complete the update
using the procedure shown in this manual.
The machine is turned off or an error has occurred.
Turn off the power, turn it back on, and then perform
the update again.
If this message reappears after you turn the power
back on, see "Error and Status Messages on the
Screen" in the User Guide.
The machine is being operated through the operation
panel.
Net Connection : FAIL(X)*1
Cancel any operations being performed through the
operation panel.
Put the machine into standby mode, and then
perform the update again.
Your computer is searching the network for the machine.
Net Server : Connecting…
Wait a while until the machine is found.
To Next Page
Loading...
