Kyocera FS-C1020MFP

System Maintenance Reference
97
Message Cause/ Solutions
Firmware has been transferred to the machine
successfully.
Net Upload : End of data
 Follow the instructions in this manual to complete the
update.
Firmware has been transferred to the machine
successfully.
USB Upload : End of data
 Follow the instructions in this manual to complete the
update.
The [F/W Update (USB)] or [F/W Update (NET)] button
was clicked when the update was already in progress.
 Clicking the [F/W Update (USB)] or [F/W Update
(NET)] button during the update process does not
interfere with any ongoing update.
 Ignore this error message and complete the update
using the procedure shown in this manual.
The machine is being operated through the operation
panel.
USB Upload : FAIL
 Cancel any operations being performed through the
operation panel.
 Put the machine into standby mode, and then
perform the update again.
→1: "X" indicates an error code.