Appendix: SP Mode Tables
36
Engine Maintenance
Horiz.Bypass
Adjusts the horizontal registration for the bypass
tray. If the machine settings are reset to the
factory defaults, this value does not change.
[-15 to 15 / 0 (Default) / 4 mm/step]
Vert.Bypass
Adjusts the vertical registration for the bypass
tray. If the machine settings are reset to the
factory defaults, this value does not change.
[-15 to 15 / 0 (Default) / 0.3 mm/step]
Horiz.Dup.Back
Adjusts the horizontal registration for the back
side in duplex mode. If the machine settings are
reset to the factory defaults, this value does not
change.
[-15 to 15 / 0 (Default) / 4 mm/step]
Registration
Vert.Dup.Back
Adjusts the vertical registration for the back side in
duplex mode. If the machine settings are reset to
the factory defaults, this value does not change.
[-15 to 15 / 0 (Default) / 0.3 mm/step]
Reset Count Resets counters to factory defaults.
Clear Count Clears the Scanner and Jam Counters.
Replace Fuser
Resets the maintenance counter for the fusing unit.
This item appears only when the fusing unit life is almost expired or
has expired.
Init Engine
EEPROM
This clears all counters except "Full Color" and "Black and White" in
the total counter.
When you execute "Init Engine EEPROM", the engine EEPROM is
initialized.
Turn the machine power off/on after you change this setting.
Model
Displays only
1:-
2: MF2c
To Next Page
Loading...
