Copying Functions
OPERATION GUIDE 4-17
When the original has been set on the
platen and the scanning of the original
completed, Place next original. is
displayed and the Combine indicator blinks.
When this occurs, carry out the following
procedure.
5
Replace the original with the next one and press [Start]. The copier will
read in the original.
6
If there are no more originals, press [Combine] or [OK]. The copier will
begin copying.
4 in 1 Layout Order
Follow the procedure below to change the order in which pages are to be
laid out within the copied page when making 4 in 1 copies.
1
Press [Combine] for 3 seconds. The
System Menu will be displayed.
2
Confirm that 45.4 in 1 Layout is displayed and then press [OK].
3
Press U or V and select the
layout.
4
Press [OK]. The display will blink and copying can be begun.
Setting the Combine mode Border Lines
Use the procedure given below to change the Combine mode Border
Lines.
1
Press [Combine] for 3 seconds. The System Menu will be displayed.
2
Press U to display 46.Combine Border.
3
Press the [OK].
4
Press U or V and select the type of border line.
Place next
original.
45.4 in 1 Layout
Portrait 1
1
1
3
4
2
4
2
3
Portrait 1 Portrait 2
Landscape 1 Landscape 2
1
1
2
4
3
4
3
2
System menu:
46.Combine Border
To Next Page
Loading...
