Kyocera KM-1635

System Setting
5-10 OPERATION GUIDE
1
Display the System Menu. (Refer to System Menu Operations
Procedures on page 5-7.)
2
Press U or V to display 04.Initial
Dens.
3
Press [OK].
4
Press U or V and select Manual or Auto.
5
Press [OK]. The display will return to that of Step 2.
EcoPrint
Selects the initial value of EcoPrint when the power is turned on. The initial
value of the EcoPrint can also be set to on (Enable).
1
Display the System Menu. (Refer to System Menu Operations
Procedures on page 5-7.)
2
Press U or V to display 05.EcoPrint.
3
Press [OK].
4
When EcoPrint is to be used as the initial value press V and select On
(Enable).
5
Press [OK]. The display will return to that of Step 2.
Exposure Steps
Changes the number of steps for the copy’s exposure.
1
Display the System Menu. (Refer to System Menu Operations
Procedures on page 5-7.)
2
Press U or V to display 06.Density
steps.
3
Press [OK].
4
Press U or V and select 1 Step, or 0.5 Step.
5
Press [OK]. The display will return to that of Step 2.
System Menu:
04.Initial Dens.
System Menu:
05.EcoPrint
System Menu:
06.Density steps