Kyocera KM-2030

4-21
Section 4 Other Features of this Fax
3. Then press the Enter key.
4. Use the cursor up or the cursor down key to select “Fax Forwarding”.
5. Press the Enter key.
6. Enter the fax number of the destination fax.
* You can enter the fax number using the keypad, abbreviated
numbers or one-touch keys. Chain dial keys can be used as well.
If you enter the fax number using an abbreviated number or
one-touch key that is already designated for F-Code Based
Communication, you can skip steps 7 through 10.
7. If you want to designate the operation as an F-Code Based
Communication, press the F-Code [SUBADDRESS] key
> If you pressed the F-Code [SUBADDRESS] key, proceed to
step 8.
> If you DID NOT press the F-Code [SUBADDRESS] key, proceed
to step 11 on page 4-22.
8. Enter the subaddress you want to use for this F-Code Based
Communication.
* The subaddress can be up to 20 digits in length and can include
any combination of the numerals 0 - 9.
2. Use the cursor up or the cursor down key to select “Program Fax
Parameter”.
(1) Registering
The following procedure must be performed when registering Fax
Forwarding information for the first time.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise the cover plate and press the Register key.
The “Program” menu will appear in the message display.
Fax Forwarding
Fax Forwarding allows documents received during designated
hours to be saved into memory and automatically forwarded to
another fax number that is registered in advance. It is possible
to use F-Code Based Communication to forward the fax
reception to the destination fax.
* If the Fax Forwarding operation is not successful, the received
documents will be printed out at your fax and then deleted from
your fax machine’s memory.
* With different types of communications such as Encrypted
Communication, etc., Fax Forwarding may not be available
depending on the type of communication.
* In order to use Fax Forwarding, it is necessary to turn it ON in
advance. (Refer to “(3) Turning Fax Forwarding ON/OFF”,
page 4-23.)
Program:
End
➪
Program Abbreviated Dial
Program 1-Touch Key
Program:
Program encryption box
Program Encryption ID
➪
Program Fax Parameter
PP
JUL-08-2001 12:00
Set Document
Program Fax Parameter:
End
➪
v :
Own Name :
v :
Enter Destination
v :68945
Enter Destination
Program Fax Parameter:
Permit Tel No.
PP
Permit ID No.
PP
➪
Fax Forwarding
PP
SubAddress:
6635
20 Digits
Enter SubAddress.
08-JUL-2001 12:00
Set original
Program:
End
➪
Program abbreviated dial
Program one-touch key
Program:
Encryp. code box regist.
Program encryption code
➪
Program fax parameter
PP
Program fax parameter:
Permit tel nr
PP
Permit number
PP
➪
Fax forwarding
PP
Subaddress:
6635
20 digits
Enter subaddress numbers
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch)
(Metric)
(Inch) (Metric)