Kyocera KM-2030

* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
2-14
Section 2 Various Functions of this Fax
5. Press the Enter key.
The corresponding operation will begin automatically.
<Note on entering fax numbers>
You can enter fax numbers using the keypad, abbreviated
numbers, one-touch keys, group dial keys and the directory.
Chain dial keys can be used as well.
JUL-08-2001 12:00
Set Document
(2) Force-Starting the Communication
You can force-start a communication that is waiting in memory,
without having to wait for the scheduled start time.
* A communication force-started through the following procedure will
then begin before any other communication.
* You can also force-start a communication that is waiting for
Automatic Redialing.
* If you want to cancel the procedure part way through, press the
Reset key. The operation panel will return to the initial mode settings.
1. Raise the cover plate and press the Information key.
The “Communication information” menu will appear in the
message display.
2. Use the cursor up or the cursor down key to select “Edit”.
Then press the Enter key.
3. Use the cursor up or the cursor down key to select “Immediate TX”
[“Immediate transmisson”]. Then press the Enter key.
* If there are no communications that are using the timer currently
in memory, an error message will appear and then the message
display will return to the “Edit” menu.
4. Use the cursor up or the cursor down key to select the document
number that corresponds to the communication that you want to
force-start.
JUL-08-2001 12:00
Set Document
Communication information:
➪
Tx result on LCD
Rx result on LCD
Edit
PP
Edit:
➪
Print
Immediate TX
Program/Change
Immediate TX: List
➪
Doc # :005
v :YDK P03
13:00 Broadcast
Immediate TX: List
➪
Doc # :007
v :KKD P01
19:00 Send
08-JUL-2001 12:00
Set original
(Inch)
(Metric)
Communication information:
➪
TX result display
RX result display
Edit
PP
(Inch)
(Metric)
Edit:
➪
Print
Immediate transmission
Program/Change
Immediate transmission: list
➪
Doc. nr :005
v :YDK P03
13:00 Broadcast
(Inch)
(Metric)
(Inch)
(Metric)
Immediate transmission: list
➪
Doc. nr :007
v :KKD P01
19:00 Send
(Inch)
(Metric)
(3) Modifying the Contents of the Communication
You can modify the information relating to a scheduled
communication that uses the timer. Information can be changed,
added, or the communication can be canceled completely.
The actual procedure and information available for modification is
slightly different depending on the type of communication involved.
The example in the procedure below is for a scheduled Broadcast
Transmission that uses the timer. If you want to modify the
information relating other types of communications, simply refer to
this example but follow the flow of the message display in order to
perform the actual procedure.
* Documents that are stored in a Confidential Box or that were received
directly into memory CANNOT be deleted using this procedure.
* You CANNOT modify a scheduled communication that is waiting
for Automatic Redialing, nor is it possible to modify a scheduled
Polling Communication.
08-JUL-2001 12:00
Set original
(Inch)
(Metric)