Section 8 Reference Information
8-10
CODE CAUSE AND/OR PROCEDURE FOR CORRECTION
U01721
A communication error occurred during transmission at high transmission speed. The destination party’s fax may not have
the corresponding high speed reception capabilities. If the destination party’s fax number was dialed using an abbreviated
number or one-touch key, change the transmission speed registered for that number to a lower setting and perform
transmission procedures again.
U01800 -
U01820
A communication error occurred during reception at high transmission speed. Perform reception procedures again after
having the transmitting party lower the transmission speed.
U01821
A communication error occurred during reception at high transmission speed. Your unit may not have the corresponding
high speed reception capabilities. Perform reception procedures again after having the transmitting party lower the
transmission speed.
U03000
Polling reception was attempted, but was unsuccessful because no documents had been placed in advance in the
transmitting party’s fax. Check with the transmitting party.
U03200
The transmitting party’s fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to
receive documents from that party’s F-Code Box, but was unsuccessful because there were no documents stored in the
corresponding F-Code Box.
U03300
An error has occured due to one of the following reasons. Check with the other party.
1 A Polling Reception was attempted in order to receive documents from the other party’s fax, but was unsuccessful
because Password Check Communication was turned ON in the other party’s fax and the necessary password did not
match.
2 The transmitting party’s fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order
to receive documents from that party’s F-Code Box, but was unsuccessful because Password Check Communication
was turned ON in the other party’s fax and the necessary password did not match.
U03400
Polling reception was attempted, but was unsuccessful because the password input in the transmitting party’s fax and the
self-station ID of the receiving party did not match. Check with the other party.
U03500
The transmitting party’s fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to
receive documents from that party’s F-Code Box, but was unsuccessful because the F-Code Box number that you entered
was not registered in the other party’s fax.
U03600
The transmitting party’s fax is one of our models and an F-Code Based Bulletin Board Reception was attempted in order to
receive documents from that party’s F-Code Box, but was unsuccessful because the F-Code password that you entered did
not match the one registered in the transmitting party’s fax.
U03700
An F-Code Based Bulletin Board Reception was attempted in order to receive documents from the other party, but was
unsuccessful because the other party’s fax does not have F-Code Based Bulletin Board Transmission capabilities or
because there were no documents stored in the corresponding box.
U04000
The destination fax is one of our models and an F-Code Based Confidential Transmission was attempted in order to
transmit documents to that party’s F-Code Box, but was unsuccessful because the F-Code Box number that you entered
was not registered in the destination party’s fax.
U04100
A transmission to a destination party’s box (ex. F-Code Box) was attempted, but was unsuccessful because the destination
party’s fax does not have F-Code Based Confidential Reception capabilities.
U04200
Encryption transmission was attempted, but was unsuccessful because the specified destination Confidential Box was not
designated for encryption reception or was not registered in the other party’s fax.
U04300
Encryption transmission was attempted, but was unsuccessful because the other party’s fax does not possess Encryption
Communication capabilities.
U04400 Encryption Transmission was attempted, but was unsuccessful because the Encryption Keys did not match.
U04401
Encryption Transmission was attempted, but the other party was not dialed because the designated Encryption Key is not
registered in your unit.
U04500 Encryption Reception was attempted, but was unsuccessful because the Encryption Keys did not match.
To Next Page
Loading...
