Kyocera KM-2030

1-17
Section 1 Basic Use of this Fax
<Table codes>
The numbers and symbols shown in the table above refer to the
following:
* : During procedures that use the message display but are not
included in the initial procedures listed in the table above,
the procedure will work just like this operation.
O: The additional operation will work unconditionally with the initial
operation.
- : Unrelated to fax operation.
X: The additional operation will NOT work with the initial operation.
m: The additional operation will work with the initial operation
under certain conditions. The adjoining numerals refer to the
following conditions:
1: Print out will be accomplished once printing is possible and
the fax is in the Fax Operation mode.
2: Direct Reception will switch to Memory Reception and print
out will be accomplished once printing is possible and the
fax is in the Fax Operation mode.
3: Printing can be stopped and copies made.
4: Settings made in the Fax Operation mode will be deleted
once the machine is switched to the Copy Operation mode.
1234
567890!@#$%
X
X
O
O
O
O
O
O
X
O
O
X
X
O
O
O
O
O
O
O
X
O
X
X
O
O
X
O
O
O
O
O
O
O
X
X
O
O
X
X
X
X
X
O
O
O
X
X
O
O
O
O
X
X
X
O
O
O
X
2
m
2
m
2
m
O
O
X
X
X
O
O
O
X
O
O
O
O
O
X
X
X
O
O
O
X
O
O
O
O
O
X
X
X
X
1
m
1
m
X
2
m
2
m
2
m
O
O
X
X
X
X
X
1
m
X
1
m
2
m
2
m
O
O
X
X
X
X
X
1
m
X
1
m
1
m
1
m
X
X
X
X
O
O
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
O
O
4
m
X
X
3
m
O
O
3
m
3
m
3
m
3
m
4
m
-
4
m
X
X
3
m
O
O
3
m
3
m
3
m
3
m
4
m
-
O
X XXOOOOOOXX
4
m
4
m
O
O
O
3
m
O
O
3
m
3
m
3
m
3
m
O
-
-
X
X
X
X
X
X
1
m
1
m
1
m
X
X
-
-