Kyocera KM-2560 - Page 41

Copying Functions
ADVANCED OPERATION GUIDE 1-27
1
In each option, the available ranges are as below.
NOTE: To specify the default width value of Border Erase, refer to Border
Erase Default on page 6-28 for details.
Use the procedure below to erase borders when copying.
1
Place the originals on the platen.
2
Press the Copy key.
3
Press [Layout/Edit] and then [Border Erase].
4
Select [Border Erase Sheet] to erase borders for an individual sheet or
[Border Erase Book] to erase borders for a book.
Use [+] or [–] to enter
the width in Border
or Gutter. Press [#
Keys] to use the
numeric keys for
entry.
Press [Individual
Border Erase] to
select the individual
border erase.
Use [+] or [–] to enter
the width in Top,
Bottom, Left or
Right. Press [#
Keys] to use the
numeric keys for
entry.
Press [Original Orientation] to select the original orientation from either
[Top Edge Top] or [Top Edge Left]. Then press [OK].
5
Press [OK].
Input units Border Erase Range
Inch Models 0 to 2"(in 0.01" increments)
Metric Models 0 mm to 50 mm (in 1-mm increments)
Status 10/10/2007 10:10
Ready to copy.
Copies
Cancel OK
Border Erase
Press [OK] to display
Add Shortcut
Border
Off
Border Erase
Sheet
"
(0.00 - 2.00)
Gutter (0.00 - 2.00)
"
# Keys
# Keys
Border Erase
Book
Individual
Border Erase
1
0.00
0.00
the image.
Status 10/10/2007 10:10
Ready to copy.
Copies
Cancel OK
Border Erase
Press [OK] to display
Add Shortcut
Top
Off
Border Erase
Sheet
"
(0.00 - 2.00)
"
# Keys
Border Erase
Book
Individual
Border Erase
Top Edge Top
Original
Orientation
Bottom
Left
Right
1
"
"
0.00
0.00
0.00
0.00
the image.