Printer
ADVANCED OPERATION GUIDE 3-5
3
Setting of page size and pen
When you have selected KC-GL as emulation mode, you can set the page
size, one of eight kinds of pens, and thickness of each pen.
The table below shows the available settings.
*: Default setting
NOTE: The default setting of thickness of pen is Pen 1:1 dot(s), Pen 2:2
dot(s), Pen 3:3 dot(s)...Pen 8:8 dot(s).
Use the procedure below to select the interface.
1
Press the System Menu Key.
2
Press [Printer] > [Change] in Emulation > [KC-GL] > [Page Set].
3
Select the print size.
NOTE: [Special Size] is the size designated in Prescribe SPSZ
command. For details of Prescribe command, refer to the Prescribe
Command Reference Manual.
4
Press [OK]. The previous screen reappears.
5
Press [Pen Adjust] > [Change] for the pen for which you want to change
the thickness (1 to 8).
Setting item Set value
Page Set B0, B1, B2, B3, A0, A1, A2, Special Size*
Pen Adjust Pen 1 to Pen 8 1 to 99 dot(s)
Status 10/10/2007 10:10
Printer - Page Set
Select print size for KC-GL.
Special Size
B1
Cancel OK
B0 B2 B3 A0
A1 A2
To Next Page
Loading...
