Sending Functions
ADVANCED OPERATION GUIDE 2-25
2
Color / Grayscale / Monochrome Selection
This feature allows you to select the select the color mode used for
scanning when sending images. You can select from Full Color, Grayscale
or Monochrome.
NOTE: To scan colored 2-sided originals using the optional document
processor, you need to add memory to the machine. Contact your service
representative.
Use the procedure below to select the color mode when sending scanned
images.
1
Place the originals on the platen.
2
Press the Send key.
3
Press [Color/Image] and then [Color Selection].
4
Press either
[Full Color],
[Grayscale] or
[Monochrome].
5
Press [OK].
6
Specify the destination, and press the Start key to start sending.
Status 10/10/2007 10:10
Ready to send.
Destination
Add Shortc ut Canc el OK
MonochromeGrayscale
Color Selection
Place original.
Full Color
1
Press [OK] to display
the image.
Select a sc anning c olor s ett ing.
Auto Color
To Next Page
Loading...
Need help?
General
