Kyocera KM-4035 - Page 73

Preparation for Usage
2-37
6
Destination Registration
Select the item to be configured using
[S] or [T] and press [Change #]. The
settings configuration screen is
displayed. Follow the screen instructions
to make the changes. When done, press
[Complete entering] to save the
destination.
7
Group Registration
Press [Information], press [S] or [T] to
select the item to be configured and
press [Change #]. The settings
configuration screen is displayed. Follow
the screen instructions to make the
changes.
Press [Destination] and press [Add
dest.]. The destination registration
screen is displayed. Press [S] or [T] to
select the destination to be added and
press [Add].
When done, press [Complete entering]
to save the group.
NOTE: Perform destination registration before group registration. Destinations will not be shown in
the list until destinations have been registered.
Group registration is not possible for Scan to FTP.
Configuring Date/Time and Time Difference
Configure the necessary regional information for the e-mail sending functionality.
The time the e-mail was sent from the scanner will be recorded as the transmission time in the
e-mail header. Follow the steps below to set the date, current time and time difference from GMT
(Greenwich Mean Time).
1
Press the System Menu/Counter key.
New Dest. Register
(Not specified)
Registra.list:Scan to PC address book
Change #
(Not specified)
(Not specified)
Setting item
IP address or host name
Name to display
Save folder No.
Setting value
Information
# of re
Register new group
(Not specified)
Registra.list:Scan to PC address book
Change #
(Not specified)
Setting item
Name to display
Password
Setting value
Information
Destination
# of re
Register new group
10.111.111.112
Registra.list:Scan to PC address book
Add
10.111.111.113
10.111.111.114
Display name
UserA
UserB
UserC
Destination
Information
dest.
Destination
# of re
Delete