How to fix moire patterns on copies from Kyocera All in One Printer?
If your Kyocera All in One Printer's copies have a moire pattern, and the original is a printed photograph, set the image quality to [Print Photo].
Why Kyocera All in One Printer cannot send document?
If your Kyocera All in One Printer cannot send a document, make sure the modular cord is correctly connected. If a send error is displayed, identify the cause of the error and try sending again. Also, verify whether TX (transmission) restriction is activated and, if so, cancel the TX restriction.
What to do if my Kyocera All in One Printer has a paper jam?
If a paper jam occurs, the Kyocera All in One Printer will stop, and the location of the jam will be indicated on the touch panel. Leave the machine on and follow the instructions to remove the jammed paper.
Why Kyocera TASKalfa 250ci All in One Printer cannot perform memory forwarding using a sub address?
The reasons why memory forwarding using a sub address may fail: * The recipient fax machine must have a sub address transmission feature for this function to work. * The entered sub address must match the one registered in the recipient fax machine. If your entry is correct, check with the recipient. Note: This machine does not use a sub address password for reception.
What to do if Kyocera TASKalfa 250ci gives Job Accounting restriction exceeded?
The number of pages used has exceeded the limit set by Job Accounting, and no further operation is possible. Press [End] to cancel the job. Try the job again after resetting the limit for paper use.
Why are documents printed improperly from my Kyocera TASKalfa 250ci All in One Printer?
If documents are printed improperly from your Kyocera All in One Printer, check that the printer driver and application software settings are set properly on your PC.
How to fix light printouts on Kyocera All in One Printer?
If your Kyocera All in One Printer prints are too light, try these solutions: * If in Auto Density mode, adjust the density level. * If in Manual Density mode, use [Image Quality] to set the correct density. * Shake the toner container from side to side. * Replace the toner container if prompted. * Replace the paper if it's damp. * Perform Drum Refresh or Laser Scanner Cleaning. * Disable EcoPrint mode.
What to do if Kyocera All in One Printer displays 'FAX box limit exceeded'?
If the FAX Box limit is exceeded on your Kyocera All in One Printer, it means the FAX Box capacity is full with document data. Press [End] to cancel the job. To proceed, either print or delete the data in the FAX Box, and then try the job again.
Why does my Kyocera TASKalfa 250ci All in One Printer often jam?
Frequent paper jams in your Kyocera All in One Printer could be due to: * Incorrectly loaded paper. Load the paper correctly. * Unsupported or poor condition paper. Remove the paper, turn it over, and reload it. * Curled, folded, or wrinkled paper. Replace the paper with new paper. * Loose scraps or jammed paper in the machine. Remove any jammed paper.
Why are images skewed when printing from my Kyocera TASKalfa 250ci?
Skewed images from your Kyocera All in One Printer may be caused by: * Incorrectly placed originals on the platen. Align them with the original size indicator plates. * Incorrectly placed originals in the optional document processor. Align the original width guides securely before placing the originals. * Incorrectly loaded paper. Check the position of the paper width guides.
General| Functions | Print, Copy, Scan, Fax |
|---|---|
| Copy Resolution | 600 x 600 dpi |
| Duplex Printing | Standard |
| Type | Color Multifunctional |
| Print Speed | 25 ppm |
| Print Resolution | 600 x 600 dpi, Multi-bit technology for print quality of 9, 600 x 600 dpi equivalent |
| Copy Speed | 25 copies per minute (A4) |
| Scan Resolution | 600 dpi |
| Fax Resolution | 200 x 200 dpi, 300 x 300 dpi |
| Memory | 1 GB |
| Hard Disk Drive | 80 GB |
| Network Connectivity | Ethernet, USB |
| Scan Features | Scan to e-mail, Scan to FTP, Scan to SMB, Scan to USB Host, TWAIN scan |
To Next Page
